14
E
E
The Power Curve Display will show the selected power level
for 10 seconds or until a new heater unit is turned on. The
power level of the last heater set will remain illuminated for 10
seconds before turning off while cooking. The heater will display
the numeric value of the power level on its digital display until
the unit is turned off.
A small red decimal light will illuminate
at the bottom right corner of the Power
level Digital Display indicating that this
heater has accepted the power level. It
will remain illuminated for 10 seconds,
or until another heater or the independent timer is selected.
ADJUST POWER LEVEL
Power level can be adjusted at any time
during cooking.
Simply select the desired heater by
pressing the ON keypad and follow the
instructions for Power Level Selection
and Power Level Acceptance.
NOTE: Be sure to select the appropriate heater before adjusting
cooking temperature.
TURN OFF HEATER
Select the desired heater and
touch OFF, “0” will display for
power level.
OR
Select the desired heater by
touching the ON keypad, then
move the power level to 0 on
the Power Slider Bar. After 10
seconds, a tone will sound, and
the heater will turn OFF. The
Hot Surface/ON Indicator Light
may still be illuminated until
the heater cools.
AUTO FEATURES
The Radiant cooktop has 4 Auto Feature selections:
• Bridge
• Double Heater
• Speed Boil
• Precise Low Power
These provide convenient and flexible cooking preset options
to accommodate different sizes of cookware and temperature
control.
USING THE COOKTOP
BRIDGE HEATER
The left front and rear heaters can be synced together to
accommodate larger sized cookware. For example, a 9"x18"
griddle specifically designed for use with glass cooktops is
recommended.
TURN BRIDGE ON
1
Select either of the two heaters and turn ON as instructed in
the section: TURN ON HEATERS.
2
Touch the BRIDGE keypad to sync the two heaters together;
a tone will sound and the Hot Surface/ON Indicator Lights
for both heaters will begin to blink indicating the BRIDGE
preset has been enabled.
3
Set power level and accept power level as instructed in
the sections POWER LEVEL SELECTION and POWER
LEVEL ACCEPTANCE.
BRIDGE may be touched before or after selecting the power
level, but it must be touched before touching the heater ON
keypad again for the power level to be accepted or before 10
seconds pass and the power level is automatically selected
if no other keypads are touched.
4
To adjust power level, select one of the heaters by pressing the
heater ON keypad and follow the instructions in the section
ADJUST POWER LEVEL.
