BEFORE OPERATION
7
COOKING WITH PRE-PROGRAMMED MEMORIES
LOCK FUNCTION
• Your oven has a lock function and is locked when
you first connect to an electrical socket. At that time
the digital display will show:
•
The lock will be set when the oven is plugged in,
you can use all functions except for the
MEMORY
key.
• To release the lock function, press the
MANUAL
key and hold for 2 seconds until the
audible sound is heard.
LOCK
indicator will
disappear and you can use the
MEMORY
key.
To lock the oven press the
MANUAL
key and
hold for 2 seconds.
• Your oven is already installed with 30 cooking
programmes for apetito products in each number
key. The first 20 programmes cannot be changed.
• The input is cancelled when any keys are not
pressed for more than 3 minutes.
• Heat the oven using the top and bottom grills
without food for 20 minutes. (For operation see
notes in GRILL COOKING, on page 13).
STOPPING THE OVEN
•
or
will appear on the display after
the time reaches zero (e.g. at the end of the
cooking time).
will disappear when the
STOP
key is pressed. If you press the
STOP
key
twice during cooking
appears. If you
press the stop key again the display will return
to
.
LET THE OVEN COOL DOWN WHILE
IS DISPLAYED TO PREVENT OVER
COOKING.
• If you wish to stop the oven during cooking:
Press the
STOP
key once or open the door.
To start the oven again, close the door and press
the
START
key within 1 minute.
• If you wish to cancel a programme during cooking,
press the
STOP
key twice.
• If you wish to erase a mistake during
programming, press
STOP
key once.
• The oven has 30 memory banks (1 - 30), the
programme numbers of Memory are made
especially for deep frozen menus of apetito.
• The total cooking times for each memory bank are
shown in the table on page 8. The memory banks
21 - 30 can be changed individually if required
(see page 16).
• In addition for all memory banks a reduce factor is
stored. It is useful if you use the same memory in
the memory banks continuously.
The reduce factor is separately made for each
programme.
The stored reduce factor for 21 - 30 can also be
changed individually if required (see page 17).
• Information in these memory banks is not lost
during power interruptions. If the power goes off,
the oven does not need to be re-programmed.
Batteries are not necessary for this type of memory.
• To check the stored programmes or reduce factors
refer to “memory check” on page 18.
R-8730 ENGLISH 12/07/2001 12:20 PM Page 7
