38
CLEANING & MAINTENANCE
Website:
http://www.sharp.co.uk/support
Help Line:
08705 274277 (office hours)
WARNINGS:
• Never adjust, repair or modify the oven
yourself. It is hazardous for anyone other
than a competent person to carry out any
service or repair operation which involves
the removal of a cover which gives
protection against exposure to
microwave energy.
• The door seal stops microwave leakage during oven
operation, but does not form an airtight seal. It is
normal to see drops of water, light or feel warm air
around the oven door. Food with a high moisture
content will release steam and cause condensation
inside the door which may drip from the oven.
• Repairs & Modifications: Do not attempt to operate
the oven if it is not working properly.
• Outer Cabinet & Lamp Access: Never remove the
outer cabinet. This would be very dangerous due to
high voltage parts inside which must never be
touched, as this could be fatal. As your oven is not
fitted with a lamp access cover, if the lamp fails, do
not attempt to replace the lamp yourself, call a
Service Technician appointed by SHARP.
If you think the oven is not working properly there are
some simple checks you can carry out yourself before
calling an engineer. This will help prevent unnecessary
service calls if the fault is something simple.
Simply answer “YES” or “NO” to the following questions:
(Put half a cup of water in the oven, on the turntable
and close the door. Select 100P and programme the
oven to cook for 1 minute.)
1. Does the oven lamp come on when it is cooking?
YES/NO
2. Does the turntable rotate?
YES/NO
3. Does the cooling fan work? (Check by placing your
hand above the air vent openings)
YES/NO
4. After 1 minute does the audible signal sound?
YES/NO
5. Is the water in the cup hot?
YES/NO
If you answer “NO” to any question first check that the
oven is plugged in properly and the fuse has not blown,
if there is no fault with either, check against the
Troubleshooting chart on page 39.
OVEN INTERIOR
Clean the microwave oven cavity after each
use with a mild detergent solution on a soft
cloth, pay special attention to the
waveguide cover.
Take care not to let soapy water drip through the small
holes in the oven walls and the cavity floor particularly
if the turntable and roller stay are removed. Excess
water spillage through these holes will cause damage
to the oven interior. It is important that the door seals
and sealing surfaces are kept clean at all times, wipe
regularly with a damp cloth.
To prevent splashing, cover food wherever possible.
TURNTABLE & SUPPORT
Leave to cool before cleaning to prevent them from
breaking.
OUTER CABINET
Wipe the outside cabinet with a mild detergent solution
on a soft cloth. The control panel must be wiped clean
whilst the door is open, therefore inactivating the oven.
• Do not allow grease or dirt to build up
on the door seals and adjacent parts, as
this may prevent the door from
closing correctly and may cause a
leakage of microwaves. To clean use
a mild detergent solution on a soft
damp cloth.
• Keep the waveguide cover clean at all times. If you
leave grease or fat in the cavity, it may overheat,
smoke or even catch fire when next using the oven.
•
Never use spray cleaners, oven keys or abrasive
scourers as these damage the surface of the oven.
WARNINGS
TROUBLESHOOTING
R-254M O/M + CkBk 13/3/01 11:13 am Page 38