A31585,R22GV,/22GT/23GT/24GT/25JT
4
START
0
0
Please check the following before calling for service!
1. Plug the power cord into a three-pronged electric-outlet. (See page 5)
2. Place one cup of water in a glass measure in the oven and close the door securely.
A. Does the oven light come on?
Yes ______ No _______
B. Does the cooling fan work?
Yes ______ No _______
(Put your hand over the back ventilating opening.)
C. If "No", please check wall outlet and circuit breaker.
3. Touch these pads:
A. Does the "ON" indicator come on?
Yes ______ No _______
B. At the end of 1 minute, is the water hot?
Yes ______ No _______
IF SERVICE IS NEEDED, PLEASE CONTACT YOUR NEARE
ST AUTHORIZED SHARP SERVICER.
1
SELECTATIME
EE Mode
Reason
Action Required
EE 1, EE 2
Magnetron failure
Call for service.
EE 3
Both magnetrons failed
Call for service.
EE 4
Voltage too high
Follow instructions on page 5 of Operation
R-23GT, R-24GT
Manual under VOLTAGE SELECT to change
and R-25JT only
from 208V to 230V. If problem is not corrected,
call an electrician.
EE 5
Voltage too low
Follow instructions on page 5 of Operation
R-23GT, R-24GT
Manual under VOLTAGE SELECT to change
and R-25JT only
from 230V to 208V. If problem is not corrected,
call an electrician.
EE 6, EE10, EE16
Thermistors failure
Call for service.
EE 7
Exhaust air temperature too high
Check that nothing is blocking air intake open-
ings on oven back or that oven exterior is very
hot. Correct. Wait a few minutes and try again.
If problem persists, call for service.
EE 8
Circuit failure
Call for service.
EE 9
Maximum time is exceeded
Check page 11 in the Operation Manual.
Touch STOP/CLEAR pad, and reprogram cor-
rectly.
EE 0
Fan lock error
Call for service.
EE17
Magnetron temperature too high
Touch STOP/CLEAR pad. Wait a few minutes
and try again. If problem persists, call for ser-
vice.
SERVICE CALL CHECK
ERROR MODE
Should any of the error indicators appear in the readout, follow the instructions:
★
★
EE 1 and EE 2: Can continue to use oven before service; however, check food carefully as additional
cooking time will be needed.
Any time the EE is flashing, the servicer should be called. When EE is not flashing, check the reason and correct.
Service is not necessary.