R-21JCA-F
26
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Make sure that the smooth surface of the ceramic shelf face
up.
4. Make sure that the rubber packing without a fin of the
ceramic shelf faces the front of the oven.
NOTE: The three (3) rubber packings with the fins and the
one (1) rubber packing without a fin are attached to
the four (4) edges of the ceramic shelf. The one (1)
rubber packing without a fin is the front edge of the
ceramic shelf.
5. Put the front edge of the ceramic shelf into the front edge of
the oven cavity bottom plate.
6. Push down the rear edge of the ceramic shelf into the oven
cavity bottom plate.
7. Now, the ceramic shelf is installed.
INSTALLATION OF CERAMIC SHELF
WARNING
Make sure that the rubber packing is not caught between the
oven door and the oven cavity front plate, to avoid possible
exposure to excessive microwave energy.
Flat face
Flat face
To right wall
of oven cavity
To left wall of
oven cavity
Antenna
motor shaft
Antenna holder
Stirrer antenna
Stirrer antenna's
big blade
Centre
Hole
Figure C-9. Derection of Antenna Motor Shaft and
Stirrer Antenna Assembly
Figure C-10. Stirrer Antenna Assembly Installation
Antenna holder
Stirrer antenna
Antenna holder
Stirrer antenna
Antenna
motor shaft
Tab
Stirrer antenna assembly
Tab
Antenna
motor shaft
Antenna
motor shaft
Oven cavity
bottom plate
Oven cavity bottom plate
Tab
Rear Edge
Push
Front Edge
Ceramic
Shelf
Oven Cavity
