EN-24
ERROR
CODE
ERROR
DESCRIPTION
CONTROL
F5
Inadequate water
supply
• Make sure the water input tap is totally open and that there is no
water cut.
• Close the water input tap, separate the water input hose from the
tap and clean the filter at the connection end of the hose.
• Restart your machine, contact for service if the error resumes.
F3
Error of continuous
water input
• Close the tap.
• Contact for service.
F2
The waste water in the
machine cannot be
discharged.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the program
cancellation command.
• If the error continues, contact for service.
F8
Heater error
• Contact service.
F1
Alarm is active against
water overflow
• Power off your machine and close the tap.
• Contact for service.
FE
Faulty electronic card
• Contact for service.
F7
Overheating error
(temperature in the
machine is
too high)
• Contact for service.
F9
Divisor position error
• Contact for service.
F6
Faulty heater sensor
• Contact for service.
If one of the program monitor lights is on and start/Pause light is on and off,
Your machines door is open, shut the door.
If the programme won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine filters are not clogged.
If the lamps “Wash/Dry” and “End” keep flashing
• The water overflow alarm is active
• Turn off your tap and contact the Sharp help desk.
If the control lamps won’t go out after a wash operation
Check if the Power On/Off button is released.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
• Dishes placed incorrectly into the machine, sprayed water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Small amount of detergent added.
• An unsuitable, weak wash programme selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
CHAPTER -9: FAILURE CODES AND WHAT TO DO IN CASE OF
FAILURE
Summary of Contents for QW-GD54R443X-DE
Page 1: ...For Life QW GD54R443X DE ...
Page 2: ......
