Sharp Plasmacluster KC-930EU, Operation Manual

Page: 9 / 200

ENGLISH
E-7
REFILLING THE WATER TANK
CAUTION
Tank Cap
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other
damaging substances, deformation and/or malfunction may occur.
• Use only fresh tap water. Use of other water sources may promote the growth of mold, fun-
gus and/or bacteria.
The unit can be used in the Clean Air Mode without
putting water in the Water Tank. When using in the Hu-
midify Mode, the Water Tank should be fi lled with water.
1
Remove the Water Tank by unlatching the
top.
2
Remove the Water Tank Cap and carefully fi ll
the Water Tank with tap water.
3
After fi lling, securely tighten the Tank Cap.
• Check to see that there is no water leaking.
• Be sure to wipe off any excess water on the outside of
the Water Tank.
• When carrying the Water Tank, hold it with both hands
so that the Water Tank opening is facing up.
4
Replace the Water Tank in the unit.
Change the water in the Water Tank every day with
fresh tap water.
The top latch will “click” in place when the Water Tank is
properly installed.
KC-930EU̲eng.indd 9 KC-930EU̲eng.indd 9 2009/09/11 11:11:01 2009/09/11 11:11:01