Sharp MX-B355W, User Manual

Page: 80 / 836

1-77
BEFORE USING THE MACHINE ► HOW TO PLACE THE ORIGINAL
DOCUMENT GLASS
This section describes the steps for setting the original on the document glass.
Allowed original sizes
When the original is a non-standard size, see the appropriate explanation below for the mode you are using.
►
COPIER: " SELECTING THE ORIENTATION AND SIZE OF THE ORIGINAL (page 2-29) "
►
FAX: " SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 4-44) "
►
IMAGE SEND: " SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 5-50) "
• Close the automatic document feeder slowly. Abruptly closing the automatic document feeder may damage it.
• Take care that your fingers are not pinched when closing the automatic document feeder.
Maximum original size
Standard size
8-1/2" (longitudinal) x 14" (transversal)
210 mm (longitudinal) x 297 mm (transversal) or A4
Non-standard size
8-1/2" (longitudinal) x 14" (transversal)
216 mm (longitudinal) x 356 mm (transversal)
1
Open the automatic document feeder.
2
Load the paper with the print side
facing down.
Place the original face down and align the top left corner of
the original with back left (at the tip of the mark
) of the
document glass.
3
Close the automatic document feeder.
After placing the original, close the automatic document feeder. If the unit is left open, parts outside of the original will be
copied in black, causing excessive use of toner.
If originals have damp spots due to correction fluid, ink or paste up glue, wait until the originals are dry before making
copies. Otherwise the interior of the machine or the document glass may be soiled.
X
Y
Mark
Document glass
scale