MX-3500N/4500N, MX-3501N/4501N 1 – 6
4)
Rotate the belt by amount 10 cm to move the application part
to the surface.
* Till the applied powder reaches the cleaner installation loca-
tion.
5)
Mount the cleaner frame UN on the primary transfer UN.
6)
Apply titanium hydroxide to the belt.
* Apply titanium hydroxide to the belt 40 times (10 times in lat-
itudinal direction x 4 times in longitudinal direction) for
4 faces (making two circuits of the belt).
* Repeat half-around application and half-around rotation
each 4 times.
* Apply titanium hydroxide not to produce bias.
(Application amount)
7)
Face the primary transfer UN upward.
* Face the primary transfer UN UPward from the cleaner UN
side.
* Take care that powders will not fly apart.
8)
Mount the primary transfer UN on the machine and execute
simulation 25-1 (3-minute belt idling) once.
9)
Check omissions in characters, and if many omissions are
found, execute simulation 25-1 once again.
10) If titanium hydroxide flies apart near the resist roller, clean it.
4
Little
Moderate
amount
Much
Cleaner UN
: Nov. 15 2006
4
