5
Attaching the stand unit (for 60/70 inch models)
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
• Be sure that two or more persons attach the stand.
CAUTION
•
Attach the stand in the correct direction.
•
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
•
After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
•
Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
1
Confirm that there are 9 screws (four M6 screws,
four M5 screws and one M4 screw) supplied
with the stand unit.
2
Attach the supporting post to the stand base.
1
Insert the claws of the supporting post into
the stand base.
2
Secure the post and the base using the M6
screws (length: 16 mm) and a screwdriver.
M6 screws
NOTE
• Tighten the screws to the holes of the mark “b”.
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion
4
Insert and tighten the M5 screws (length: 14 mm)
into the holes on the rear of the TV.
M5 screws
5
Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten the M4 screw (length:
8 mm) into the holes of the stand cover.
• Tighten the screw by pressing the bottom of the
stand base to the TV side.
M4 screw
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.
• The TV can be rotated up to 20 degrees to the right and
left.
Preparation
Summary of Contents for LC-60LE855E
Page 94: ...13P05 PL NG ...
