Sharp LC-32LE510E, Service Manual

Page: 15 / 122

15
LC-32LE510
LC-40LE510
Operation Manual (Continued)
English - 12 -
Connecting to a DVD Player
via Component Sockets
(YPbPr) or Scart Cable
Some DVD players are connected through
•
COMPONENT SOCKETS (YPbPr) . In this case,
you must use the supplied Component video
connection cable for enabling connection. First,
plug single jack of the cable to the TV’s YPbPr
socket (side). Afterwards, insert your component
cable’s (not supplied) connectors into the socket
part of the Component video connection cable (see
illustration below). Colours of the connected jacks
should match.
To enable audio connection, use the
•
VGA/Component
Audio cable . First, plug single jack of the cable
to the TV. Afterwards, insert your DVD player’s
audio cable’s connectors into the socket part of the
VGA/Component audio connection cable (
see
illustration below
). Colours of the connected jacks
should match.
YPbPr
Side view
DVD Player
Connection Cable
(supplied)
YPbPr Video Cable
(Not supplied)
When the connection is made, switch to
•
YPbPr source. See,
Input selection
section.
Note: To connect YPb Pr device, you should use supplied
component (YPbPr) connection cable
You may also connect through the
•
SCART input.
SPDIF
SCART
VGA
Coax.OUT
1 2
Scart
Cable
(not supplied)
External device
Note • : These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Do not plug out the USB/HDD during the recording.
•
This may harm the connected USB/HDD.
Only two partitions on a HDD unit can be
•
supported.
Some stream packets may not be recorded because
•
of signal problems, so sometimes video may freezes
during playback.
Record, Play, Pause, Display (for PlayListDialog)
•
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.
Connecting to a DVD Player via HDMI
Please refer to your DVD player’s instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
If your DVD player has an
•
HDMI socket, you can
connect via HDMI for better video and audio quality.
SPDIF
SCART
VGA
Coax.OUT
1 2
External device
(not supplied)
HDMI Cable
When you connect to DVD player as illustrated above,
•
switch to the connected HDMI source. See,
Input
Selection
section for more information on changing
sources.
A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_32942LED_YPBPR_ROCKER_10072504_50185693.indd 12 29.06.2011 17:21:28