5
KB-0333KS
KB-0333KK
KB-0333KW
CONTROL ASSEMBLY and CONTROL PANEL SERVICING
1. Switch OFF power at service panel, to prevent accidental
electrical shock, or damage to components.
2. Remove FILTERS and set aside.
3. Remove two #8 screws (A) attaching BOTTOM COVER
(B) to HOOD, tip BOTTOM COVER down and remove.
4. Remove the two #6 (C) and three #8 (D) pan head
screws attaching the LIGHT PANEL (E) to the HOOD
and lower thE LIGHT PANEL to expose the LIGHT
CONNECTOR (F).
5. Disconnect the LIGHT CONNECTOR (F) and set the
LIGHT PANEL aside.
6. Remove the four #8 pan head screws (G) attaching the
AIR CHUTE (H) to the HOOD. Pull forward slightly on the
AIR CHUTE and slide to the right and remove.
7. If replacing the CONTROL ASSEMBLY, use a small flat
blade screwdriver to unlock the connector locks and
disconnect the plugs (I) from the CONTROL ASSEMBLY
(J).
8. Using a utility knife, carefully lift the KEY UNIT (K) and
remove from the CONTROL PANEL (L) to expose the
screws.
9. Remove the three screws (M) attaching the CONTROL
PANEL and CONTROL ASSEMBLY to the HOOD and
remove both from hood.
.
INSTALLATION
10.Position the CONTROL ASSEMBLY (J) into the HOOD,
place the CONTROL PANEL (L) over the assembly and
install the three #6 flat head screws (M). Secure in place.
Do Not overturn the screws.
11.Peel the backing from the new KEY UNIT (K), align the
KEY UNIT with the CONTROL PANEL and carefully
press in place.
12.Align the two CONTROL ASSEMBLY connectors (I) and
plug each into the new connectors until they lock in place.
13.Place the AIR CHUTE (H) into the HOOD and secure in
place with four #8 pan head screws (G).
14.Place the LIGHT PANEL (E) into the HOOD frame. The
front lip of the LIGHT PANEL must be slid behind the
HOOD frame lip. The remaining edges of the LIGHT
PANEL lay over top of the HOOD edges.
15.Secure the LIGHT PANEL to the HOOD using two #6 (C)
and three #8 (D) pan head screws. Reconnect the
LIGHT CONNECTOR plug (F).
16.Set the BOTTOM COVER (B) in the back edge of the
HOOD and tip up into place and secure with two #8 pan
head screws (A).
17.Install the FILTERS.
18.Switch ON power at the service panel and test the
RANGE HOOD functions.
