Sharp FO-90, Service Manual

Page: 8 / 108

1 – 6
UX-68ES/F/GG/IT
FO-90IT
4. Loading the fax paper (FO-20PR6)
• Your fax machine prints incoming faxes on a special kind of paper
called fax paper.
• The fax machine’s print head creates text and images by applying
heat to the fax paper.
1
Grasp the finger hold as shown and pull up to open the operation
panel.
2
Flip up the front paper guide.
Press the knob to make sure the
front side of the metal guide is down.
UX-68
FO-90
YES
NO!
4
Unwrap the roll of thermal paper and place it in the compartment.
♦
Important: The roll must be placed so the leading edge of the
paper unrolls as shown. (The paper is only coated on one side for
printing. If the roll is placed incorrectly, the paper will come out
blank after printing.)
UX-68
FO-90
Click!
5
Insert the leading edge of the paper into the slot as shown. Continue
to push the paper through the slot until it comes out the opening in
the front of the machine.
6
Make sure the paper comes out straight, and then flip down the pa-
per guide.
7
Close the operation panel, making sure it clicks into place.
•
A short length of the paper will be cut off. (FO-90)
•
A short length of the paper will feed out. Grasp the paper by the
edge and pull upward to tear it off. (UX-68)
3
If you are loading paper that is 210mm in width, place the paper roll shims
on each side of the paper compartment. (Note that Sharp recommended
paper, including the initial roll, is 216mm in width.)
•
The ribbed side of the shims should face in (toward each other).