15
6
Tub side
Maintenance
3. Confirm
if the top
lid is
closed.
4. Press START
/PAUSE key.
1. Detach lint filter box
from washing tub.
2. Clean lint filter box
and the tub side.
3. Attach lint filter box on
washing tub to a down-
-ward direction.
1. Turn off
the
faucet.
2. Turn on
the power
and press
WATER
LEVEL
key.
Make sure the
water in the hose
has been drained.
About 10 seconds
later, turn off the
power.
5. Dismantle
water inlet
hose.
Caution
The filter net is very easily blocked when it is used for a long period.
Clean it in the following way.
6. Clean the
filter net.
Caution
1. Every time after washing, turn off the faucet and power. (If necessary,
dismantle water inlet hose.)
2. Wipe the water in the tub after washing as soon as possible.
Use clean soft cloth.
3. Be sure to pull out the plug from the plug socket during maintenance.
4. Hanging power cord and drain hose is desirable.
5. Open top lid for about 1 hour after cleaning the tub.
6. Do not use solvents such as alcohol, cleanser and so on, because they
may cause damage to the surface of the tub.
Remove the filter
net and clean it.
Twist connecting
part, not hose.
Lint filter box
Clean it every time after using
Water inlet hose connecting port
Washing / Spin Drying tub
When the draining hose is not long enough,
please use extension hose.
The length of used extension hose should not exceed 1.5m.
(The inner diameter of draining hose is about 3.8cm).
If the hose is too long, it can be cut off at the narrow part shown
in the figure.
If a floor drain is used, the height from the ground
should not be under 10 cm.
If the drain hose is too high, the water supply will not
stop. This time, you should adjust the drain hose so that
the clearance to the floor is below 10cm, The water will
drain out, and then start again.
Plug the drain hose into the drain port tightly. If the drain
hose drops, water will flow to the ground and damage the floor.
Please do not plug the drain hose to the inside or bottom of
washing machine.
Change the direction of drain hose
Under
10cm
Cut the hose diagonally.
(not easily blocked)
If the elevation of
drain hose is too high,
situations such as “the
water supply is not
stopped but the running
stops” will happen.
If the drain hose is
folded or broken, it
will lead to longer
draining time or even
the abnormal stoppage.
Cut the hose if it is too long.
Cut the hose
diagonally.(not easily
blocked)
Wrong placement
Correct placement
Below 10cm
Under 10cm
Under 1.5m
Cut the hose diagonally.
(not easily blocked)
Drain hose
Cut
Installation
See Installation manual for detail.
