Sharp ES-FW105D7PS, Operation Manual

Page: 15 / 40

Water inlet installation
>
10m
m
Tap selection
S ui table ta p
Not sui table ta p
T h e f ront end s hou l d be longe r t ha n 10mm. T h e ta p e xit end face
s hou l d be flat and s moo t h , i f not f il e i t to a void lea k ag e.
I nlet ho se
I nlet ho se connecto r
S lid e r
Sc rewdriv e r
B olt
Bushi ng
B ef or e t wis t ing ,abo u t 4mm
Afte r twis t ing ,less 2mm
Nu t
Illu st ra t io n 1 Illus t ra t io n 2 Illus t ra t io n3
Illus t ra t io n 6 Illus t ra t io n 5 Illu st ra t io n 4
p a t e h t o t r o t c e n n o c e s o h t e l n i e h t t c e n n o C
1 . Press down the slider and remove the inlet ho se connecto r from the inlet ho se ,
like below illu st ra t io n 1.
2 . Loosen t h e f our bolts on t h e i nlet ho se connecto r till t h e ta p can be access ed , t he n
set t h e i nlet ho se connecto r i n t h e t ap, see illu st ra t i on 2 .(i f t h e ta p ca li b er is too l arge and
co u l d not set t h e i nlet ho se end , un sc r e w t h e f our bolts and t ak e ou t t h e bushi ng, ta p exit
end mu s t be flat, otherwise it will leak, see illustration 3)
3 . Fasten t h e f our bolts i n t h e i nlet ho se connecto r e v enl y , see illu st ra t i on 4 .
4 . Twi st t h e fasten i ng nu t as t h e illu st rati on ,see illu st ra t i on 5 .
Remark bef or e t wi st in g t h e nu t, t h e t hreadi ng is abo u t 4mm above t h e upp e r s ur face of t h e nu t, afte r t wi st ing ,
t h e t hreadi ng i s less t ha n 2mm abo v e t h e upp e r s ur face of t h e nu t, see illu st ra t io n 6 .
Installation
14