EN-19
EN-4
EN-7
EN-6
Terminal
EN-15 and 16
Back side
STORAGE
Tips
Replacing Battery
Storing Product
Precautions for Details
When the product is not
used for a long time.
Care is needed when leaving the product standing leaning against a wall, as the
product may fall.
Store the product in the condition described in the diagram below when not using
the product for a long period of time.
Store the product by hooking the holder section on furniture or the like, in a gap between a furniture
and the wall, in the corner of the room or inside a closet where the product is unlikely to fall.
Care must be taken as the holder section may slide and leave pigment on the
contacted surface, depending on the type of the wall or furniture.
If the product cannot be easily secured by hooking due to slippery floor or furniture,
do not force the product to hook at a location but disassemble the product for
storage instead.
Verify that there is nothing in the vicinity of the product that can be damaged easily.
Pay particular attention to ensure no infant or pet is allowed to get near the product.
Holder
section
There may be cases where the floor surface is damaged when the
roller switch on the bottom side of the Suction head, wheels or
the Napped cushion is worn.
Wheel
Napped cushion
Napped cushion
Integrated with
Suction head
Integrated with
Rotary brush
cover
Roller
Switch
In the event the part becomes
worn it is necessary to replace it
with a new one.
Stop using the product and contact
your nearest service center
approved by SHARP.
The replacement of the part for the
is performed while the product
is left with Sharp.
Replacement part (Rotary brush
cover) is available for purchase.
Do not drag the charger (Risk of scratching on the floor
surface).
This product is for indoor use only.
Do not operate the product while the Dust cup assembly
has been removed.
Large dirt or a large amount of dirt suctioned at the same time.
Sharp objects (glass, razor blade and the like).
Liquid or moist dirt.
A large amount of sand.
(Risk of heating, ignition of fire or
electrocution.)
Furthermore, store the product in a
location where there is little humidity
or dust.
Do not transport or store the product
together with any metal object, such
as a needle, necklace or hair pin.
It is recommended that the power
plug of the charger be removed from
the power outlet.
The charger consumes about 0.5 W
of power while the power plug is
connected to the power outlet.
Removing the power plug when the
charger is not in use can keep down
wasteful power consumption.
Consider following precautions
when storing the battery.
Remove the battery from the base
unit and completely charge the
battery before storing.
Twines
Do not apply lubricant to the Rotary brush (Risk of
plastic parts cracking).
Do not hit the Suction head hard on the steps on the
floor surface or gaps in floor heights, as well as
furniture or wall (Risk of the floor surface becoming
scratched).
Clean respective filters when fine powder (plaster, cement,
chalk and the like) has been suctioned.
Do not suction any of the following types of items
(Risk of scratching of the product interiors and clogging of the
product, as well as product malfunction).
This cordless vacuum cleaner is intended for
household use and must not be used for commercial
applications. Furthermore, the product must not be
used for any purpose other than cleaning.
There are instances where the operation of the
product causes noise to appear on the screen of
television sets. There is no negative impact on
the television set when this occurs.
There is no malfunction if the the Charging lamp (red) on
the charger blinks slowly when charging in an
environment with a low temperature (about 5°C or lower)
or a high temperature (about 35°C or higher).
Charge the battery in an environment that is between
5°C to 35°C.
Recommended time for replacing
the battery.
When the Charging lamp (red) of the charger blinks slowly
whenever charging in an environment with room temperature of
between 5°C and 35°C.
When the operating time is extremely short even when the battery
has been charged.
We invite you to recycle the spent battery.
Information on handling of spent battery.
Insulate the terminal sections using plastic tape or the like that are available on the market.
Furthermore, do not disassemble the product.
The battery (lithium-ion battery) is a precious resource that can be recycled.
Bring in the spent battery to a store that accepts batteries for recycling, rather than disposing of
them as waste material.
Batteries are consumable products.The operating time
gradually becomes shorter as the battery deteriorates with
repeated use. Although the deterioration of batteries vary
depending on the condition of use or operating
environments, the battery should be replaced if any of the
following conditions apply.
CAUTION
EN-5
EN-3
Warning
Caution
Danger
EN-20
EN-4
0.13 L
SAFETY PRECAUTIONS
SPECIFICATIONS
Information on Battery
Preventing accidents and major injuries from
electrocution or fire disaster and the like.
Matters for preventing electrocution, fire disaster, electricity leaks
and major injuries
Matters for preventing electrocution, fire disaster and
malfunction of base unit
(Risk of heating, ignition of fire or electrocution.)
(Risk of heating, ignition of fire or electrocution.)
(Risk of harm to the eyes.)
(Risk of heating, smoke generation, bursting or ignition of fire.)
(Risk of fire disaster, electrocution or injury.)
(Risk of heating, smoke generation, bursting, ignition of fire or liquid leakage.)
(Risk of heating, smoke generation, bursting or ignition of fire.)
Use and store the product in a location where there is little humidity or dust.
Stop charging the battery if the charging is not completed even after exceeding the
prescribed charging time and replace the battery.
Keep the battery at a place that is out of reach of infants.
Do not touch the battery with a wet hand.
Always use a battery that is specified by Sharp.
Do not use any charger for a battery that is not specified by Sharp.
Do not immerse or wet the product with water.
Do not place the product near fire or space heater, a location exposed to direct sun light
or at a location with high temperature such as inside a car parked under the flaming sun
and the like.
Do not throw the product into fire or heat it.
Do not use any battery that has been deformed or scratched from dropping and the like.
Do not pierce the product with a nail, hit with a hammer, step on the product or otherwise
give strong impact or throw the product.
Do not allow any metal object, such as a needle or a pin to contact a terminal and do not
transport or store the product with such articles as necklaces or hair pins.
Do not use the battery when there is emission of smell, heat, liquid leakage, discoloration,
deformation and any other abnormality that was not present previously.
When the liquid from inside the battery leaks and comes in contact with the eye, do not
rub and immediately rinse out the liquid from the eye using clean water such as tap water
and receive treatment by a physician right away.
Do not use the battery with any appliances other than the vacuum cleaners manufactured
by Sharp and do not disassemble, modify or separately charge the battery.
When the liquid from inside the battery leaks and comes in contact with the skin or clothing,
immediately rinse out the liquid from the eye using clean water such as tap water.
A battery must be charged in an environment with the temperature in the range of 5°C to
35°C.
(Risk of heating, generation of smoke, bursting and ignition of fire, as well as improper charging or
deterioration of the battery.)
(Risk of harm to the skin.)
When a single battery is used (fully charged and initial condition of the battery / 20°C).
Conditions may vary depending on the material of the floor surface, environment in which the product
is used and the condition under which the product is used.
Cord length
charger dimensions
Base unit dimensions
Weight
Charging time
Dust collecting capacity
Electric power consumption
Continuous operation
time*
Power supply method
Power supply
Input 100 - 240 V 50-60 Hz (charger)
Rechargeable type (lithium ion battery, 18V )
While charging: Approx. 40 W; After charging: Approx. 0.5 W
1.5 kg (Suction head, pipe, base unit and battery included)
0.6 kg (charger)
222 mm W x 220 mm D x 980 mm H
200 mm W x 90 mm D x 133 mm H
80 cm (charger)
Approx. 80 minutes (charging may take up to maximum of
about 2 hours depending on the conditions of use, such as
the surrounding temperature or duration of use)
High mode: Approx. 8 minutes
Standard mode: Approx. 30 minutes
INSTRUCTION MANUAL FOR BATTERY PACK ( BY-5SB )
“ Charging Information ”
Nominal Specifications
Item
Specifications
Remark
0
～
10
℃
10
～
60
℃
0
～
45
℃
45
～
60
℃
0
～
60
℃
Charging Current (Std.)
Charging Voltage (Std.)
Charging cut current
1.95A
3.90A
20.75V
20.25V
100mA
Charge Limits
Battery Pack Model Maximum Charge Current, A
BY-5SB
Maximum Charge Voltage, V
3.9A(0
～
10
℃
)
20.87V
7.8A(10
～
60
℃
)
“ Disposal method and Storage method ”
After extended periods of storage, it may be necessary to charge and
discharge the cells or batteries several times to obtain maximum
performance. Do not store cells or batteries haphazardly in a box or drawer
where they may short-circuit each other or be short-circuited by other metal
Replace only with same SHARP Corporation type BY-5SB battery pack.
Dispose of used batteries according to local ordinances and/or regulations.
objects. Keep cells and batteries clean and dry.
EC-A1RA_Eng_A4(ai sorted).indd 20
2017/07/07 11:43:22
