Troubleshooting chart (continued)
Care of compact discs
■
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
NO
YES
Correct
Maintenance
Cleaning the cabinet
■
Periodically wipe the cabinet with a soft cloth and a
diluted soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
Cleaning the CD pickup lens
■
Poor performance during CD playback (skipping or jumping)
can be caused by a dirty or contaminated CD laser pick up
lens. If this happens then the use of a commercially available
CD lens cleaning disc may restore normal operation.
Contact your supplier or local CD software dealer to obtain
CD lens cleaning discs. Ensure all included instructions/
documentation are carefully followed.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification
changes for product improvement without prior notice.
The performance specification figures indicated are
nominal values of production units. There may be some
deviations from these values in individual units.
General
■
Power source
AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 24 W
Power stand-by: 0.4 W (*)
Speaker
1-way speaker system
Speaker: 10 cm (4”) - 6 ohms - Full Range
Speaker
maximum input
power
50 W/channel
Speaker rated
input power
25 W/channel
●
●
●
●
●
Dimensions
Width: 475 mm (18 - 11/16”)
Height: 191 mm (7 - 1/2”)
Depth: 83 mm (3 - 1/4”)
Weight
2.45 kg (5.4 lbs.)
( * ) This power consumption value is obtained when the
demonstration mode is cancelled in the power stand-by
mode. Refer to page 5 to cancel the demonstration mode.
Amplifier
■
Output power
MPO: 50 W (25 W + 25 W)
(10% T.H.D.)
RMS: 50 W (25 W + 25 W)
(10% T.H.D.)
RMS: 40 W (20 W + 20 W)
(1% T.H.D.)
Output terminals Headphones: 16 ohms
(recommended: 32 ohms)
Input terminals
Audio In (audio signal):
500 mV/47 k ohms
CD player
■
Type
Single disc multi-play compact disc
player
Signal readout
Non-contact, 3-beam
semiconductor laser pickup
D/A converter
Multi bit D/A converter
Frequency
response
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
USB (MP3 / WMA)
■
USB host
interface
Complies with USB 1.1 (Full
Speed)/2.0 Mass Storage Class.
Support Bulk only and CBI
protocol.
Support file
MPEG 1 Layer 3
WMA (Non DRM)
Bitrate support
MP3 (32 ~ 320 kbps)
WMA (64 ~ 160 kbps)
Other
Maximum total number of MP3/
WMA files is 65025.
Maximum total number of folders is
999 INCLUSIVE of root directory.
The ID3TAG information supported
are TITLE, ARTIST and ALBUM only.
Supports ID3TAG version 1 and
version 2.
File system
support
Support USB devices with
Microsoft Windows/DOS/FAT
12/FAT 16/ FAT 32.
2 kbyte block length for sector.
Tuner
■
Frequency range FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Preset
40 (FM and AM station)
DK-KP82PH_OM_EN_SCA.indd 22
2013-02-26 07:33:25
