Tuning
■
Press the ON/STAND-BY button to turn the power on.
Press the FUNCTION button on the main unit or
TUNER button on the remote control repeatedly to
select FM Stereo, FM Mono or AM.
Press the TUNING ( or ) button on main unit or
remote control to tune in to the desired station.
Manual tuning:
Press the TUNING ( or ) button repeatedly to tune
in to the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for more
than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may
stop automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING ( or )
button again.
When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed first, and then the
RDS indicator will light up. Finally, the station name will
appear.
Full auto tuning can be achieved for RDS stations
“ASPM”, see page 16.
To receive an FM stereo transmission:
Press the TUNER button to select stereo mode and
“ST” indicator will be displayed. “
” and “ ” will
appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER button
to extinguish the “ST” indicator. The reception changes
to monaural, and the sound becomes clearer.
1�
2�
3�
●
●
●
●
●
●
●
●
●
Memorising a station
■
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
Perform steps 2 - 3 in “Tuning”.
Press the MEMORY button.
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
Within 30 seconds, press the MEMORY button to
store that station in memory. If the “MEMORY” and
preset number indicators disappear before the station
is memorised, repeat the operation from step 2.
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for
a few hours should there be a power failure or the AC
power lead becomes disconnected.
To recall a memorised station
■
Press the PRESET ( or ) button for less than 0.5
seconds to select the desired station.
To scan the preset stations
■
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
Press the PRESET ( or ) button for more than
0.5 seconds. The preset number will flash and the
programmed stations will be tuned in sequentially, for
5 seconds each.
Press the PRESET ( or ) button again when the
desired station is located.
To erase entire preset memory
■
Press the FUNCTION button (main unit) repeatedly
or TUNER button (remote control) to select Tuner
function.
In Tuner function, press the CLEAR button until “Tuner
Clear” appears.
1�
2�
3�
4�
5�
1�
2�
1�
2�
Listening to the radio
DK-KP82PH_OM_EN_SCA.indd 15
2013-02-26 07:33:22
