Sharp CD-BK100W, Service Manual

Page: 45 / 64

– 45 –
CD-BK100W/CD-BP90W
T
T
DOUT
Stopped
CH1=2 V
DC 10:1
500 ns/div
1999/04/07 09:25:28
(500 ns/div)
NORM:200 MS/s
1
=Record Length=
Smoothing : ON CH1 : 0.00 V
CH2 : 0.00 V Main : 1 K
Zoom : 100 Mode : NORMAL
Type : EDGE CH1
Delay : 2.887 ms
Hold off : 0.2
µ
s
CH3 : 0.00 V
CH4 : 0.00 V
BW : FULL
=Trigger= =Filter= =Offset=
T
FDO
PDO2
PDO1
Stopped
CH1=500 mV
DC 10:1
CH3=1 V
DC 10:1
CH4=1 V
DC 10:1
500 ms/div
(500 ms/div)
NORM:20 kS/s
1
4
3
=Record Length=
Smoothing : ON CH1 : 0.000 V
CH2 : 0.0 V Main : 100 K
Zoom : 2 K Mode : AUTO
Type : EDGE CH2
Delay : 0.0 ns
Hold off : 0.2
µ
s
CH3 : 0.00 V
CH4 : 0.00 V
BW : FULL
=Trigger= =Filter= =Offset=
CH1
v/DIV
500 mV
1999/04/05 17:33:17
Is pin 35 (C2F) on IC2 "L" ?
Yes
No
The HF waveform is normal and the time is displayed
normally, but no sound is produced. Or the sound
has dropouts.
(5) Others.
There are too many error flags on a damaged disc which
makes error correction impossible.
Check again using a known good disc.
1. When playing at normal speed.
Check the peripheral circuit at pin 37 (DOUT) on IC2 and
the waveform (Figure 45-2).
If OK, Check the unit.
When a disc is loaded, start play operation.
(4) PLL system check.
The HF waveform is normal, but the TOC data cannot be
read.
Check the PDO waveform. (Figure 45-1)
Check around pins 1~6 on IC2.
Figure 45-1
Figure 45-2