– 43 –
CD-BK100W/CD-BP90W
Vp-p=1.0 V~1.3 V
0.5 mV/div,0.5
µ
sec/div
T
FDO
DRF
TE
Stopped
CH1=500 mV
DC 10:1
CH2=10 V
DC 10:1
CH3=1 V
DC 10:1
500 ms/div
(500 ms/div)
NORM:20 kS/s
1
2
3
=Record Length=
Smoothing : ON
CH1 : 0.000 V
CH2 : 0.0 V
Main : 100 K
Zoom : 2 K
Mode : AUTO
Type : EDGE CH1
Delay : 0.0 ns
Hold off : 0.2
µ
s
CH3 : 0.00 V
CH4 : 0.00 V
BW : FULL
=Trigger=
=Filter=
=Offset=
-3 div
-1 div
0 div
+1 div
+3 div
CH Position To
CH2
Position
0.20 div
T
FDO
TDO
Stopped
CH1=500 mV
DC 10:1
CH3=500 mV
DC 10:1
500 ms/div
(500 ms/div)
NORM:20 kS/s
1
3
=Record Length=
Smoothing : ON
CH1 : 0.000 V
CH2 : 0.0 V
Main : 100 K
Zoom : 2 K
Mode : AUTO
Type : EDGE CH1
Delay : 0.0 ns
Hold off : 0.2
µ
s
CH3 : 0.000 V
CH4 : 0.00 V
BW : FULL
=Trigger=
=Filter=
=Offset=
CH1
v/DIV
500 mV
If the level is not normal, check around pins 27~29 on IC1.
1. Is focus servo activated ? (Waveform drawing Figure 43-2)
Pins 1~11 on IC1
Check the laser diode driver Q3 peripheral circuit.
Forcus error circuit (pins 20 and 21 on IC1).
When a disc is loaded, start playback operation.
2. Does DRF change from "L" to "H" ?
Is the disc rotating ?
3. Is the HF waveform normal ?
(Waveform drawing Figure 43-3)
Check the spin system.
If the disc is spinning and a HF waveform is generated,
DRF will go H.
Figure 43-1
Check the laser diode driver Q3 peripheral circuit.
(1) Focus-HF system check.
Although a CD is inserted and the cover is closed, "NO
DISC" is displayed.
1. Does the pickup move to the PICKUP-IN Switch (SW4)
position ?
Sled motor (M2).
Press the OPEN/CLOSE switch (SW1) without inserting a
disc, and try starting the playback operation.
2. Does the focus (lens) move up and down ?
(Waveform drawing Figure 43-1).
Check the focus peripheral circuit.
3. Is the laser lit ?
Spindle motor (M1).
4. Is the turntable rotating ?
Figure 43-2
Figure 43-3
Yes
Yes
Yes
No
No
No
No
No
No
No
Yes
Yes
No
Summary of Contents for CD-BK100W
Page 54: ...CD BK100W CD BP90W 54 M E M O ...
