37
R-930CS
Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
CHOKE COVER
1. Place door assembly on a soft cloth with latches facing
up.
Note: As the engaging part of choke cover and door panel
are provided at several places, do not force any particular
part.
2. Insert an putty knife (thickness of about 0.5mm) into the
gap between the choke cover and corner portion of door
panel as shown Figure C-6 to free engaging parts.
3. Lift up choke cover.
4. Now choke cover is free from door panel.
DOOR DISASSEMBLY
CHOKE COVER
PUTTY KNIFE
FRONT
INSIDE
Upper
Lower
Bent
Door
Panel
Choke
cover
1 BENT
2 LIFT UP
DOOR PANEL
5. Remove the twelve (12) screws holding the door panel
to the door frame.
NOTE: The one (1) screw of the twelve (12) screws also
holds the earth terminal of the door decoration to the
door frame.
6. Remove the door panel from the door frame. Now the
door panel is free.
DOOR GLASS
7. Remove the two (2) screws holding the thermal plate U
to the door frame.
8. Remove the two (2) screws holding the thermal plate R
to the door frame.
9. Remove the thermal plate U and the thermal plate R from
the door frame.
10.Slide the door glass leftward.
11.Slide the door glass upward.
12.Remove the door glass from the door frame. Now the
door glass is free.
DOOR DECORATION AND DOOR FRAME
13.Straighten all tabs of the door decoration.
14.Remove the door decoration from the door frame.
15.Now the door decoration and door frame are free.
Figure C-6. Door Disassembly
