Sharp BD-HP21X, Operation Manual

Page: 22 / 48

20
Loading the Batteries in the Remote
Control
Hold in the tab on the battery cover and pull the
cover towards the direction of the arrow.
Load the two “AA” size batteries (R-06 size,
UM/SUM-3). Place batteries with their terminals
corresponding to the
m
and
n
indications in
battery compartment.
Insert the smaller tab of the battery cover into
the opening
1
, and press down on the cover
until it clicks in place
2
.
NOTE
Do not subject the remote control unit to shock, water or
excessive humidity.
The remote control unit may not function if the Player's remote
sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst. Read
the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control unit for
an extended period of time. •
•
•
•
•
1
2
3
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on the rear
of the Player. Then plug into AC outlet.
NOTE
Place the Player close to the AC outlet, and keep the power plug
within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE
UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD
IS CONNECTED.
The STANDBY indicator blinks while the Player is preparing for
starting up. You cannot turn the Player on until the STANDBY
indicator stops blinking. •
•
•
Before Starting Playback
Approximate operating range of remote
control
Remote control sensor
Remote control unit
30º 30º
7 m
To AC IN terminal
To AC outlet
Disc Playback
BD-HP21X_en.indd 20 BD-HP21X_en.indd 20 2008/09/17 13:04:59 2008/09/17 13:04:59