2. Installation
Packed items
1
Rail unit
1
2
Lock plate
1
3
Rail unit fixing screw
2
4
Mounting kit fixing screw (M4 x 18)
4
5
Sorter fixing screw (M4 x 10)
2
6
Stapler position label A (for the copier)
1
7
Stapler position label D (for the RADF)
1
Pull out the power plug of the copier from the
power outlet, and follow the procedures below.
Setting of the copier and the stapler sorter
1. Remove the notch sections of the copier, and install
the rail mounting plate fixing screw.
Use nippers to cut out the two cut-out sections on the upper side of
the left cabinet of the copier. Use a screwdriver to punch out the four
cut-out sections on the lower side. (There are 6 cut-out section in
total.)
2. Fix the rail unit fixing screw temporarily as shown in
the figure.
3. Install the rail unit
Hang the rail unit on the upper rail unit fixing screws which were fixed
temporarily in procedure 2.
Tighten the mounting kit fixing screw in the position shown in the
figure.
Tighten the upper rail unit fixing screws which were temporarily fixed.
1
2
6
7
3
4
5
Cut-out
Cut-out
Rail unit fixing screws
Rail unit
Mounting kit fixing screws
AR-SS2
2 – 2