AR-D21/D22
UNPACKING AND INSTALLATION
– 3 –
5. Connect the harness.
Connect the cassette interface harness contained in the optional paper
feed unit to the paper feed unit interface PWB.
• For two tray type
• For one tray type
6. Attach the rear covers of the copier and the optional
paper feed unit.
Attach the rear covers of the copier and the optional paper feed unit
using two screws respectively.
7. Remove the securing fixture for packing the paper feed
unit and remove the packing material.
Remove the securing fixture for packing that fixes the paper pressure
plate of the tray by rotating it in the direction of the arrow and remove
the packing material.
Caution: Be sure to remove the securing fixture bofore turning on the
power.
8. Change the paper size in the tray.
Hold the grip and slide the cassette side plate to adjust it to the paper to
be used.
Then, fit the rear end plate to the specified size position.
Insert the power plug of the copier to the outlet and turn on the
main switch of the copier. Then, carry out the following procedure.
9. Load paper into the paper tray.
Do not exceed the maximum height line.
10. Check for center displacement.
• Set an original on the document glass and copy it using the paper
tray in the copier.
Then, copy an original using the attached optional paper feed unit.
• If the center of the copy image from the tray in the copier is different
from that of the copy image from the optional paper feed unit, carry
out adjustment referring to the service manual.
Installation of Paper feed unit is now complete.
Cassette relay harness
Cassette relay harness
Rear cover
Real cover
Screws
Screws
Securing fixture for packing
Packing material
Rear plate
Side plate