Sharp AR-215, Operation Manual

Page: 131 / 152

KEY OPERATOR PROGRAMS
129
KE
Y
OP
E
RATOR'S
G
U
IDE
8
Erase Adjust
Set the initial setting of the amount of the erase area with this program.
When "ERASE ADJUST" is selected and the OK key is pressed, the following display will appear.
●
This program can be used only if an optional dual function board is installed.
1. Adjust the value for the edge erase mode and centre erase mode
using the and keys.
●
The value can be set from 5 mm to 20 mm in 5 mm increments (from 1/4" to 1" in 1/4"
increments).
2. Press the OK key.
Stream Feeding
This program is used to enable the stream feeding mode of an SPF or RSPF. When the stream feeding
mode is enabled, additional originals which are set in the document feeder tray within 5 seconds after
the previous original was fed will be fed and copied automatically.
To enable the stream feeding mode, highlight "STREAM FEEDING" and
press the OK key to display a check mark in the check box.
To disable this function, select this program and press the OK key again to
clear the check mark in the check box.
Rotation Copy
If this program is set, the image of originals will rotate when the orientation of the originals does not
match that of the copy paper.
Rotation copy will function only when the auto paper select or auto image mode has been selected.
●
This program can be used only if an optional dual function board is installed.
NOTE:
If the image is rotated in reduction copying, the position of the image in relation to copy paper will
vary with the orientations of the originals and copy paper.
To enable rotation copy, highlight "ROTATION COPY" and press the OK
key to display a check mark in the check box.
To disable this mode, select this program and press the OK key again to
clear the check mark in the check box.
ERASE ADJUST
1
/
4
mm
(5~20)
ERASE ADJUST
1
/
4
inch
(1/4~1)
Original Copy paper Copy
!AR-215_EX.book 129 ページ ２００３年１月１０日 金曜日 午前１０時２４分