AR-168N/168L TEST COMMAND, TROUBLE CODES 10 - 28
50
18
Memory reverse position
adjustment in duplex copy
(DPLX REVERSE) (Enabled
when Duplex setting is ON
with OC or SPF set)
[Function]
When this test command is executed, the current set correction value is displayed.
Enter the correction value and press [START] key to save the entered correction value. (Correction
value range; 1 – 99, Default: 50)
For S-D mode front surface print and print of even paged in D-S mode, reverse memory copy opera-
tion is performed from the rear edge of documents.
When, therefore, the print position adjustment of output images is required, adjust as follows:
In the reverse memory coping, when the document scan is made in the arrow direction, the output
image is printed from the rear edge of scan image,
When, therefore, the print lead edge is shifted, set the reference chart so that the reference position is
on the rear edge, and use this test command to adjust the set value so that the print lead edge is
matched.
Since printing is made from the image data most lately stored in memory to the lead edge data from
the print start position, the image lead edge adjustment is made by changing the end data position
stored in memory by the set value of this test command.
Since it is performed by changing the scan end position, the image position adjustment is made by
changing the scan end position and the end data stored in memory.
∗
The initial value of duplex setting is "1to2/Long Edge" for the duplex model, or "2to1" for the simplex
model.
∗
When paper is discharged, the shifter is operated.
[Operation]
The operation is similar to test command 46-01.
19
Duplex copy rear edge void
adjustment (DPLX END
EDGE) (Enabled when
Duplex setting is ON)
[Function]
Used to adjust the rear edge void amount in duplex copy.
When this test command is executed, the current set value is displayed in 2 digits. (Center value: 50.)
The adjustment modes can be selected by pressing [
←
/
→
] key. (Adjustment range; 1 – 99)
Enter the adjustment value and press [START] key to save the set value and make a copy. (The
paper information is cleared for every copy.)
When the set value is increased by 1, the void amount is increased by about 0.1mm.
∗
The initial value for duplex setting is "1to2/Short Edge" for the OC/SPF setting, or "2to2" for the
RSPF setting.
∗
When paper is discharged, the shifter is operated.
[Operation]
The operation is similar to test command 46-01.
Main
code
Sub
code
Contents
Details of function/operation
*1: Only when SPF/RSPF is installed. If installed, skipped.
Mode
Display item
Default
LED
OC memory reverse output position
OC
50
COPY mode lamp
SPF memory reverse output position *1
SPF
50
PRINT mode lamp
Document transport direction
Document transport direction
Scan lead edge
Print lead edge
Lead edge void (1)
Print start position
Scan end position
(Default: Scan cut by void (1))
Rear edge void
Print rear edge
Scan direction
Scan rear edge
Mode
Display item
Default
LED
Paper rear edge void amount
DEN-B
50
PRINT mode lamp
Print start position (Duplex back surface)
RRC-D
50
SCAN mode lamp
10̲TESTCOMMAND.fm 28 ページ ２００５年１１月１８日 金曜日 午後５時３７分
