Sharp AN-S422E, Service Manual

Page: 34 / 178

34
XG-V10WE
AN-SD1E/S422E
No. Adjusting point Adjusting conditions Adjusting procedure
S3 "
Delivery setting 3
"
Remote controller
setting
Process
adjustment
»
Make the following settings.
34 Lens perform-
ance checking
»
Using the set's control switch or the remote control-
ler, make sure the focus, zoom, keystone and lens
shift actions are as specified.
35 Delivery set-
tings 1. When the S4 delivery set-
tings have been made, the
SET-UP signal is accept-
able.
If the process mode is
called up again, however,
the SET-UP signal is not
automatically accepted. In
such case, select Group:
VIDEO1 and Subject: SET
UP, change the SET UP
setting from 0 to 1, and exit
from the process mode. Or
make the S4 delivery set-
tings again.
The methods of colour correction adjustment, after LCD panel is replaced.
When not use colour correction system.
No. Adjusting point Adjusting conditions Adjusting procedure
1. Make the following choice.
Group : NOKO
Subject : CC
»
If the colour is irregular, adjust the setting NOKO-
G or NOKO-R to minimize the right-hand and left-
hand colour irregularity.
»
If there is no colour irregularity, turn off the saw-
tooth correction using SW4201 (green) and
SW4202 (red).
1 Colour correc-
tion Rest
»
Make the following setting.
Subject : CC
Setting : 0 (colour correction OFF)
1. Feed the gray only RGB col-
our signal. (XGA 60Hz)
2. Check for uneven colour
spot on the screen.
3. Make the following choice.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKO-
R for the R Colour.
2 Saw-tooth wave
Correction (G),
(R)