Sharp AN-37AG2, Operation Manual

Page: 37 / 172

E-5
ENGLISH
Included part: Wall-mount bracket
As the screw hole numbers become larger (5, 10, 15,
20), the LCD color TV will be tipped farther forward.
There is a limit to the angle that can be set depending
on the model.
Install so that the
angle-setup bracket
spacers are facing
inward.
Included part: Angle setup bracket (2 units)
Included part: Screws M6 15mm length (2 screws)
Included part: Wall-mount bracket
5° 10°
15°
20°
Caution
Setting the installation angle.
1
Remove the 2 vertical installation screws. These screws are used when setting the
angle.
Set the angle of the wall-mount bracket
2
Assemble the wall-mount bracket as desired as shown in the figure. (Figure shows
a 20˚ angle.) Use the screws removed in Step 1 (M6 length: 15mm x 2 screws) and the
included screws M6 length: 15mm x 2 screws to loosely fasten the angle-setup bracket
with 4 screws. Firmly tighten these 4 screws after the angle-setup bracket position has
been determined.
• When setting the angle of the wall-mount bracket, be careful not to pinch your
fingers, etc.
• There is a limit to the angle that can be set depending on the model.
The wall-mount bracket is assembled for perpendicular installation, so to use it for tilted
installation, please follow the procedure below to set it at the installation angle.
Setting Angle Model Name
LC-37BD5, LC-37HV4, LC-37AD2, LC-30BV5, LC-30BV3,
LC-30HV3, LC-30HV2, LC-30HV4, LC-30AD2, LC-37U5-B/-R,
LC-37L5-B/-T, LC-37W5C/K, LC-32GD4
LC-32GD2, LC-32G4
LC-30HV6, LC-30AA1, LC-30AD1*(2), LC-37AD1, LC-37HV6,
LC-37AA1, LC-37GD2, LC-37G4, LC-37GD3, LC-37GD6
LC-37GD1, LC-32GD1, LC-45GD1, LC-45GX6
LC-30AD1*(1), LC-37GD4, LC-32GD3, LC-32GD6
0˚, 5˚, 10˚
15˚, 20˚
0˚, 5˚, 10˚, 15˚
0˚, 5˚, 10˚
0˚, 5˚
0˚
Setting Angle Chart
*(1) Models for which the destination market is Japan.
*(2) Models for which the destination market is other than Japan.
AN-37AG2̲E
04.8.10, 6:59 PM Page 5
Adobe PageMaker 6.5J/PPC