AL-2041 SIMULATION, TROUBLE CODES 10 - 7
26
04
Machine duplex setup
(AL-2041 only)
[Function]
When this simulation is executed, the current set duplex is displayed. Enter the code number
corresponding to the desired duplex and press [START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
06
Destination setup
[Function]
When this simulation is executed, the current set destination is displayed. Enter the code num-
ber corresponding to the desired destination and press [OK]/[START] key to save the setting.
* Code number 2 and 3 cannot be selected.
[Operation]
The operation is similar to simulation 26-02.
07
Machine conditions check
[Function]
When this simulation is executed, the current machine setting is displayed.
20
Rear edge void setup
[Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
30
CE mark support control
ON/OFF
[Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [START] key
to save the setting.
[Operation]
The operation is similar to simulation 26-02.
38
Cancel of stop at drum life
over
[Function]
When this simulation is executed, the current setup of the code number is displayed. Enter the
code number and press the [START] key to enable the setup.
[Operation]
The operation is similar to simulation 26-02.
39
Memory capacity check
[Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
Main
code
Sub
code
Contents
Details of function/operation
Code number
Duplex
0
Duplex NO
1
Duplex YES
Code number
Destination
0
Inch series
1
EX Japan AB series
2
Japan AB series
3
China
CPM
Copy quantity
Remark
20 CPM
20
Code number
Setting
Remark
0
Rear edge void NO
1
Rear edge void YES
Default
Code number
Setting
Remark
0
CE mark support control OFF
Default (100V series)
1
CE mark support control ON
Code number
Setup
0
Stop at drum life over * Default (AL model)
1
Cancel of stop at drum life over
Code number
Setting
Remark
32
32 MBYTE
