TO OPERATE ON FAN:
TO USE THE
ENERGY SAVE FEATURE:
TIMER:
TIMER ON/OFF
YOU WILL SEE:
YOU WILL SEE:
YOU WILL SEE
HOW MUCH TIME IS CHOSEN:
DO THIS:
LIGHT On
LIGHT On
LIGHT On
PRESS
MODE BUTTON
CHOOSE
FAN
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVE
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
TEMP/TIMER
SET BUTTON
Note:
Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air. (Remember to open the
Note:
In this mode, the fan will continue to run for another 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes
Note 1:
For
Timer Off
, the unit must be in the On position.
Note 2:
For
Timer On
, the unit must be in the Off position.
To adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at
0.
5 hour increments, up to 10
hours, then
at
1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The
Timer On
mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the
set temperature, press "
MODE
" then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the con-
trol will automatically change the display back to the hours remaining until the unit will start/stop.
Turning
the unit
"
On
" or "
Off
"
at any
time
will cancel the
Timer On/Off
function. The
Timer On/Off
Feature will work until the unit either starts or stops. Once that happens
the above
steps have to be repeated again.
at 10 minute intervals until the room temperature is above the set temperature, at which time the the cooling system turns back on.
vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer. (Exc-
ept "Auto
Cool
").
During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode.
▲
▲
