Sharp 55R-WP5H, Service Manual

Page: 48 / 112

50
61R-WP5H
55R-WP5H
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
1. The unit of resistance "ohm" is omitted.
(K=k
Ω
=1000
Ω
, M=M
Ω
)
2. All resistors are 1/16 watt, unless otherwise noted.
3. All capacitors are µ F, unless otherwise noted.
(P=pF=µµF)
4. (G) indicates ±2% tolerance may be used.
5.
indicates line isolated ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000µ V B & W or Color
signal.
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å
AND SHADED ( ) COMPONENTS
= SAFETY RELATED PARTS.
'
MARK= X-RAY RELATED PARTS.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
WAVEFORMS
R8723
T701 13-pin
IC6503 4-pin IC6503 2-pin IC618 1-pin P618 3-pin
Q672 G T631 1-pin FB655 IC601 3-pin
(H) 120Vp-p 120Vp-p
(H) 9Vp-p (59k) 250Vp-p
(V) 1.3Vp-p (V) 5.2Vp-p (H) 4.0Vp-p (H) 9.5Vp-p
(H) 160Vp-p (H) 1600Vp-p (H) 0.8Vp-p
120Vp-p (59k) 3.0Vp-p (59k) 310Vp-p
R8823 R8923 IC701 1-pin IC701 3-pin