Sharp 14VT10X1, Service Manual

Page: 27 / 138

3.
4.
5.
Remove the slow brake spring
Remove the slow brake shaft cap
Remove the slow brake lever
Remove the ring
6.
7.
Rotate the take-up loading gear, take-up
loading arm assembly, supply loading gear and
supply loading arm assembly slightly in the
loading direction, and take them all out.
Remove the ring
Remove the relay gear drive lever
Reassembly
Reverse the procedure. Be sure to match the
tally marks on the gears.
Figure
Notes
1. When reassembling, apply specified grease to
the following points; all the gear teeth, all the
gear shafts and the cam groove of loading
relay gear.
2. Be careful not the deform the supply/take-up
loading arms.
3. Be careful to keep clean the slow brake lever
felt.
4. Be also careful to keep the outer surface of
the capstan D.D. motor free from dust and
dirt. (If stained, the MR (Magnet Resistor)
element might be damaged.)
5. Take care not to deform the anti-fall hooks of
slow brake shaft cap and supply/take-up
loading gears more than required.
REMOVAL AND REASSEMBLY OF LOADING
BLOCK
Removal
Remove the leads
2. Remove the cassette loading belt
3. Unscrew the three screws
4. Pull the loading
block upward.
Leads
Master
Note
Figure l-67.
When using a magnetic screw driver in removal
of three screws, do not allow the magnetic driver
to hit the A/C head or drums.
l
Reassembly
1. Turn the master cam all the way counter-
clockwise.
2. Match the tally mark on the cam switch with the
mating mark. Fit the loading block and the
master cam
with
each other. Tighten up the
three screws.
C a m
Figure l-68.
3. Finally connect the leads and apply the cassette
loading belt.
Notes:
Be careful not to scratch the gear.
2. Be careful not to stain the belt. If dirty, clean it
up
with the specified
cleaning liquid.
REPLACEMENT OF LOADING MOTOR
1. Set the cassette ejected condition by placing the
unit in the cassette eject mode.
2. Unplug the power cord.
3. Remove the loading block in accordance with
the statements and drawings above.
29