420 774 335 397 www.sharks-shop.cz Stránka 28
OPERATION
1) Select the welding mode
Use the welding mode switch (1) to select the desired welding mode.
To select MMA welding, set the switch to "
" to select MIG welding,
set the switch to "
".
2) Turn on the unit
Plug the power cord plug into a 230V single socket. Press the on / off
button on the back panel to "I", the power light (green) lights up.
To turn off the device, press the on/off button on the back panel to the
"O" position. The power indicator goes off.
NOTICE!
Never turn off the device before completing the job.
1. After welding, allow the machine to run for a while to cool sufficiently. When the yellow light is on,
thermal protection has been triggered. The cooling time of the welding machine is from 2 to 5 minutes
depending on ambient temperature.
2. "Test" indicator - if this light is on, it means that the welding machine is overloaded. It is necessary
to remove the plug from the socket and wait for about 10 seconds and then try to turn it on again. If
the light is no longer lit, you can work. If the light does not go out, disconnect the appliance, do not use
it and contact a Sharks Authorized Service Center.
●
Semiautomatic arc welding with an inert gas (MIG)
MIG welding (with connected gas hose)
- Connect the MIG burner (1) to the MIG terminal. Insert
the end of the welding cable correctly into the machine
opening and secure with the locking nut.
- Connect earth wire (2) to terminal "-". Insert the
connecting end of the earthing clip into the
corresponding machine opening and rotate it. Connect
the ground clamp to the object to be machined as close
as possible to the welding point.
NOTICE!
Connect the MIG/MAG adjustment cable (3) to the "+"
terminal using the MIG method.
Connecting gas supply
- Connect the gas hose to the gas bottle. Various types
of gas are used for different welding types.
- For carbon steel welding, carbon dioxide (CO2) or a
mixture of gases (80% Argon-Ar + 20% carbon dioxide - CO2) is used.
- A gas mixture (98% Ar + 2% CO2) is used for welding stainless steel.
- For pure aluminum welding use pure Argon (Ar 99.95%)
- Set gas consumption (7-15 l / min)
- The tip should have the same diameter as the welding wire. Remove
the nozzle and unscrew the tip
