SHARKS SH 250 W, Instruction For Operation And Maintenance

Page: 31 / 68

420 774 335 397 www.sharks-shop.cz Stránka 31
30. Avoid using the machine in bad weather conditions especially when there is a risk of lightning.
31. the declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another
32. the vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool’s construction and design:
1)
Damage to lungs if an effective dust mask is not worn.
2) Damage to hearing if effective hearing protection is not worn.
Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
WARNING! This machine produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of serious or
fatal injury, we recommend persons with medical implants to consult their physician and the medical
implant manufacturer before operating this machine.
ASSEMBLY AND USE
Mounting the guard (Fig.A)
Insert the guard (1) into the carrier and secure trimmer using the enclosed screw (2).
Caution! During this operation beware of the wire cutter blade. You may be wounded.
Caution! Never use the grass trimmer without the guard ,It is vital for your and other peoples’safety
and for the good working roder of the trimmer . The failure to observe these safety regulations is not
only dangerous but also annuls the guarantee terms.
Starting
If the trimmer is to be used for the first time, check that the nylon wire touches or passes over the wire
cutting blade. The nylon wire will be cut automatically when turn on the switch to the maximum length.
If it does not reach the necessary length, adjust it as described in chapter replacement. Push the
button and make the trimmer turn at no load; thus, the line length is automatically adjusted. Only
approach the implement to the grass to be cut while it is in operation, i. e . while the suitch is pressed
down.
To cut long grass, take several small cuts, Never cut wet or very damp grass. The line has to be
protected against premature wear caused by hard obstacles; for this purpose, keep the trimmer away
from hard surfaces using the guard’s edge as a protection. A short or worn line will reduce cutting
capacity So. To restore the line to its optimum length, push the implement to the ground while it is
running ; this way, the line will automatically be the correct length (Fig.B).
CAUTION! The short or worn wire cuts less efficiently therefore, to improve its operations, unplug the
electrical supply and repeat the operation described in the beginning of the chapter. These make sure
that everything is functioning properly and to familiarize yourself with the grass trimmer.
CAUTION! After switching off. The nylon wire will continue to rotate for a few more seconds.
Replacement of the line spool (Fig.C)
Unplug from the socket.
Turn upside down the machine with the guard facing upwards.
Hold with one hand the motor fan (1) firmly and with the other hold the spool holder (2). Push this
fan of the spool holder both side down and pull it out of the motor fan.
Extract the empty spool (3) and clean the inside of the spool holder carefully removing al ground
and grass residues.
Insert now the new spool in the motor fan and push the end of line through the lateral holes
provided on the motor fan.
Push the spool holder on and fasten it securely.
Re-establish the length of the nylon line by pushing the head of spool holder and pull the line
ends out to the desired length (appron.15cm).