420 774 335 397 www.sharks-shop.cz Stránka 24
SPECIAL PRECAUTIONS
1. Before placing a grinder into operation for the grinding bodies undergo soundcheck (flawless
grinding bodies are banging at light - plastic hammer - clear sound). This also applies when they are
clamped new grinding bodies (damage during transport). The machine must always be subjected to
test run without load for at least 5 minutes. It should be danger area forsake.
2. May be used only grinding tools which carry details of the manufacturer, type of binder sizes
and the permissible number of revolutions.
3. Grinding bodies must be stored in a dry place at a temperature as constant as possible.
4. clamping of the grinding bodies may only be used in conjunction supplied clamping flanges.
5. For clamping abrasive elements may be used only as large and well shaped clamping
flange. Interlayer between the clamping flange and the grinding housing must be elastic
materials. For example rubber, soft cardboard etc.
6. Bore grinding bodies may not be subsequently drilled.
7. workpiece support and the adjustable upper guards must be set close to the abrasive
bodies, as far as possible (distance max. 3 mm).
8. abrasive body must not be operated without protective equipment. Must not be the following
distance exceeded:
- Workpiece support/grinding wheel: max. 2 mm
- Guard/grinding wheel: max. 2 mm
9. Before using double disc grinders must be fitted protective bracket, bracket
workpiece and eye protection.
10. To replace the grinding wheel must first remove the power plug.
11. Max. circumferential speed of the wheels for dry grinding is: BNTS 150 = 23.16 m / s
12. Max. permissible temperature of the motor housing: 80 ° C
13. Fill the black water tank fine grinding wheel to the shaft axis with water.
14. Before starting work, screw grinder with 4 fixing holes in the base plate
on the desk, etc.
15. Setting antisparkle protect perform periodically, so that the wear plate
symmetrical, whereby the distance between the disc antisparkle protection and maintain
as small as much as possible and in any case not greater than 2
16. As can be observed distance antisparkle protection (3) and abutment surfaces
workpieces (7) of max. 2 mm from the disc must be at least now grinding wheel replaced.
17. Only use grinding wheels recommended by the manufacturer that have written speed
rotation that is equal to or greater than the speed indicated on the nameplate of the machine.
TECHNICAL SPECIFICATIONS
voltage/frequency:
230V/50Hz
power consumption: 250 W
dry disc
speed:
2 950/min
dimension:
150x20x12,7 mm
rudeness:
K36
wet disc
speed:
134/min
dimension:
200x40x20 mm
rudeness:
K80
weight:
11.5 kg
package includes:
support for the workpiece (7), a vent sparks (3)
