11
teXtIleS
teXtIle PARtS
type
The textile and foam parts providing comfort
to the SHARK Vantime make it easy for you
to appreciate the performance of your helmet
to the best.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the risk
of mould and bacteria.
Always in one concerns of hygiene, the
outer seal are treated against bacteria, what
allows avoiding their proliferation when we put
the helmet.
treatment
Warning:
although they are selected for their
quality of resistance and satisfactory wear,
all the interior padding is subject to normal
wear depending on use and care and mainte-
nance, the length of use and also the degree
of acidity of your perspiration.
If you note any wear, we advise you to replace
the interior padding in order to keep your
helmet perfectly clean and comfortable.
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not correspond
to the contours of your face.
maintenance
The interior textile parts are washable;
it is important to follow the instructions below
scrupulously to avoid damaging them.
The cheek pads and head section must
be hand washed in warm, soapy water (about
30°).
Do not use aggressive detergents
but either a product for delicate materials
in low dilution or household soap.
It is essential to dry textile and foam parts
completely before using them. They must
be dried at room temperature. Never iron
textile parts.
For parts with a leather appearance or textiles
attached to safety elements, use a slightly
damp sponge or cloth and household soap
and rinse with clean water.
Avoid allowing
too much water to come into contact with
polystyrene parts.
It is essential to ensure that all interior parts
are perfectly dry before using the helmet.