SHARK SSG • 97-614 • REV. 6/06
9
PRESSURE
W
ASHER
OPERA
TOR’S MANU
AL
OPERATING INSTRUCTIONS
STEP 8:
Pull the starter grip. If the engine fails to start
after 2 pulls, squeeze the trigger gun to release pres-
sure and repeat step. Return starter gently. After the
engine warms up enough to run smoothly, move choke
to run position and throttle to fast position.
CAUTION: Small engines may kick back. Do not
hold pull starter grip tightly in hand.
WARNING! Never replace
nozzles without engaging the
safety latch on the spray gun
trigger.
The four color-coded quick connect
nozzles provide a wide array of
spray widths from 0° to 45° and are
easily accessible when placed in
the convenient rubber nozzle holder,
which is provided on the front of the
machine.
NOTE:
For a more gentle rinse,
select the white 40° or green 25°
nozzle. To scour the surface, select
the yellow 15° or red 0° nozzle. To
apply detergent select the black
nozzle.
NOZZLES
Safety
Latch
STEP 9:
Turn the burner “ON”. Turn temperature
control dial to the 210° mark.
burner
Temperature
Control
STEAM COMbINATION
Step 1:
For steam, open the steam
valve counterclockwise.
This lowers the pressure and raises
the temperature.
Step 2:
Turn the temperature con-
trol knob to the 270° mark, (This
is a high limit device and does not
regulate temperature).
Step 3:
To stop, reverse steps. Set all
controls to their original settings.
Step 4:
Turn burner switch off, open
trigger on spray gun and allow water
to cool.
Steam
valve
Temperature
Control
burner Switch
