8
9
Freephone: 0800 862 0453
www.lakeland.co.uk
NOTE
: The first time that you use the
Sonic
Duo
™
there may be air in the system causing a delay
for the solution to come out of the spray nozzle.
Hold the spray button down for 5 to 10 seconds
until you see the solution come out.
6
Lightly step on the back of the scrubbing head
to release the handle and move the agitating
Sonic
Duo
™
back and forth over the area to
clean tough, dried on stains faster and easier.
Repeat until the entire floor surface has been
cleaned. No rinsing is required.
WARNING
: Never stand on the
Sonic Duo
™
.
7
Press the Spray Button to apply solution onto the
floor that is to be cleaned. (
Fig. 28
)
8
If the Reusable Bottle is empty, you can refill
it at any time as long as the
Sonic
Duo
™
is
unplugged from the outlet.
IMPORTANT:
Never leave the
Sonic Duo
™
with a damp/wet cleaning pad on any floor
surface for any amount of time as this may
damage the floor.
9
Once finished, step on the tag of the Hard Floor
Cleaning Pad and lift the unit to remove the pad
from the
Sonic
Duo
™
. (
Fig. 29
)
Using Your Sonic Duo
™
Carpet, Wood & Hard Floor Cleaner - cont.
IMPORTANT
: Make sure the floors are swept
or vacuumed before using the
Sonic
Duo
™
.
4
Twist the quick release cord holder to unwrap
the power cord completely. (
Fig. 25
)
Plug into an electrical outlet and slide the “On/
Off” button down to turn the
Sonic Duo
™
on.
Use “
I Low
” setting for hard floor cleaning.
(
Fig. 26
)
5
Make sure that the Hard Floor Cleaning Pad
is attached to the
Sonic Duo
™
. This pad has
a “Green” trim and the tag says “Hard Floor
Cleaning Pad”. Attach the side of the Cleaning
Pad with the tag to the back of the
Sonic
Duo
™
. (
Fig. 27
)
fig. 28
fig. 25
fig. 24
IMPORTANT:
When cleaning, do not use the
Sonic Duo
™
without attaching a Hard Floor
Cleaning Pad and adding the diluted cleaning
solution to the Reusable Bottle first. When
polishing, do not use the
Sonic Duo
™
without
attaching a Hard Floor Polishing Pad.
Cleaning Your Hard Floors:
1
To remove the Reusable Bottle, hold it and pull it
up to remove from the unit. (
Fig. 22
)
2
Remove the “Green” bottle cap. Add 1 part of
the Sonic Activated Wood & Hard Floor Cleaner
solution to 7 parts water into the Reusable Bottle.
Use the measuring marks on the Reusable Bottle
for easy measuring and filling. (
Fig. 23
)
Always
fill with cold water first up to the “Water Fill
Line” and then add the cleaning solution up
to the “Solution Fill Line” to avoid foaming
and to ensure accuracy
.
3
Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit upside down. Push
it down to make sure that it is well inserted. You
will hear an audible “Click” when the Reusable
Bottle is inserted properly. (
Fig. 24
)
IMPORTANT
: Do not use on unsealed wood
or unglazed ceramic floors. Do not use on wood
or tile floors that are highly worn, unfinished or
have a wax or oil finish. Surfaces that have been
treated with wax or some no wax floors may be
damaged by the cleaning and polishing solutions
therefore it is always recommended to test an
isolated area of the surface to be cleaned before
proceeding. You should always check the use and
care instructions from the floor manufacturer.
fig. 22
fig. 23
fig. 26
fig. 29
fig. 27
Frequently Asked Questions
Q.
My
Sonic Duo
™
leaves a foam on hard floors.
A.
The
Sonic Duo
™
Hard Floor Cleaning Pad is
likely too saturated. Replace it with a clean,
dry pad.
Q.
My floors appear cloudy after cleaning.
A.
The
Sonic Duo
™
Hard Floor Cleaning Pad
may be dirty. Change the pad.
OR
A.
The
Sonic Duo
™
Hard Floor Cleaning Pad
was washed with a powder detergent and
may be damaged and require replacement.
Never use powder detergents. Only use liquid
detergent to launder the cleaning pads.
OR
A.
The
Sonic Duo
™
may have been left in the
same spot for too long with a wet cleaning
pad. Never leave the unit with a wet pad in
one spot for too long.
OR
A.
This may be leftover from past cleaners
that were used on the floor surface. Use the
Sonic Duo
™
a few more times and see if the
leftover cloudiness is removed. If this does not
work, we suggest rinsing the floor with water
and letting it dry. One or more rinses generally
removes the residue. A more stubborn case
may require you to rinse the floor with a mix
of one part vinegar to 2 parts water. Then use
the
Sonic Duo
™
again with a clean pad.
