Shark SH2000, User Manual

Page: 10 / 32

USER’S MANUAL
10
Under ON state, press the (MODE) key, the player swit
-
ches from U disk or SD/MMC card playing state to radio
state; release the (MODE)key, the player switches from
radio state to U disk or SD/MMC card playing state. When
no U disk or SD/MMC card is in the player, it can’t switch
to U disk or SD/MMC card playing state after releasing the
(MODE) key.
3. Volume Adjustment (VOL)
Under Radio or Playing state, turn the volume knob
clockwise to increase volume, turn it anticlockwise to drop
volume.
4. Adjust Time
Under SD/MMC card or U disk playing state, press the (H)
key to adjust Hour; press the (M) key to adjust minute.
Radio
Tune (TUNE): Under Radio state, turn the tune knob
to receive your favorable band. Turn the knob clockwise
to increase frequency, turn it anticlockwise to decrease
frequency.
Player Operation
1. Playing Switch
Under SD/MMC card playing state, insert the U disk, the
player automatically switches to U disk playing state, insert
the SD/MMC card, the player automatically switches to
SD/MMC card playing state.
2. Select Music:
Back / REW (|<<): Under U disk or SD/MMC card playing
state, press the (|<<) key to switch to previous program; hold
the (|<<) key for over 2 seconds to select program quickly
backward.
Next / FF (>>|): Under U disk or SD/MMC card playing
state, press the (>>|) key to switch to Next program; hold
the (>>|) key for over 2 seconds to select program quickly
forward.
note:
A. The player supports SD/MMC card and U disk whose
capacity is 32MB~2GB.
B. The player supports MP3 audio format.
C. The player has memory function.
trouble shooting
Before using the check list please make all the connec
-
tions first. If you still have questions after going through
the checklist, please consult your local customer service
representative. When replacing fuse, please select the fuse
of same specification, do not replace it with others.
Fault Reasons Solutions
Power indicator
doesn’t light on
1.Power supply
is not correctly
connected.
2.Fuse is broken
or power circuit is
open.
Correctly connect
power supply.
Check and con
-
nect power wire,
replace fuse.
No sound
1.No power supply.
2. Speaker wire is
open circuit.
3. SD/MMC card,
U disk don’t have
song with corre
-
sponding format.
4. SD/MMC card,
U disk golden
finger is dirt which
causes bad
contact.
Connect the power
wire.
Connect speaker
wire. Check the
contents of SD/
MMC card, U disk.
Clean with abso
-
lute alcohol.
Low sound
(not clear)
1.Power internal
resistance is high.
2.Antenna is bad
contact.
Replace the power
supply.
Tighten the an
-
tenna plug.
Mono track
1.One channel of
speaker wire is
open circuit.
2.Amplifier inte
-
grated circuit is
damaged.
Connect speaker
wire.
Replace the IC of
amplifier.