8
NZ: 0800 002 999
7
Lightly step on the back of the scrubbing head to
release the handle.
WARNING
: Never stand on the
Sonic Duo
™
.
8
Begin cleaning by pressing the Spray Button to
apply the cleaning solution to the carpet that
is to be cleaned. (
Fig. 12
) Spray the solution
continuously while pushing the unit forward
and then pulling it backward until the area to be
cleaned is damp.
NOTE
: The first time that you use the
Sonic
Duo
™
there may be air in the system causing a
delay for the solution to come out of the spray
nozzle. Hold the spray button down for 5 to 10
seconds until you see the solution spray out.
9
Using the same back and forth motion, continue
to go over the area a few times without spray.
Work your way through the room or area being
cleaned methodically. Repeat as necessary until
the entire carpeted area has been cleaned. No
rinsing is required.
10
If the Reusable Bottle is empty, you can refill
it at any time as long as the
Sonic Duo
™
is
unplugged from the outlet.
11
Once finished, step on the tag of the Carpet/
Rug Cleaning Pad and lift the unit to remove
the Carpet/Rug Cleaning Pad from the
Sonic
Duo
™
. (
Fig. 13
) Let the carpet dry thoroughly
and then vacuum.
fig. 12
fig. 13
HIGH TRAFFIC AREA CLEANING
Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
2
Spray the Activating Pretreater Carpet Stain &
Odour Remover to pretreat the area. Spray the
area until saturated and let sit for 5-10 minutes.
Step 2:
3
Attach the
Carpet Scrub‘n Stain
™
Pad
to
the bottom of the
Sonic Duo
™
. This pad has a
“Purple” Trim and tag that says
Carpet Scrub
‘n Stain
™
Pad
. Attach the pad as shown in
(
Fig. 14
) – the tag should be positioned toward
the back of the
Sonic Duo
™
.
4
Remove the Reusable Bottle by holding it and
pulling up. (
Fig. 15
) Remove the cap by turning
it counterclockwise.
5
Fill the Reusable Bottle with the “Purple” Trim
and label with water until the “1:3 Water” fill
line and then with the Low Moisture –No Rinse-
Carpet Cleaner until the “Solution” fill line.
(
Fig. 16
)
Always fill with water first and then add
the cleaning solution to avoid foaming and
ensure accuracy when measuring.
fig. 14
fig. 16
fig. 15
