Shark GS500QUK, Instruction Manual

Page: 13 / 16

13
Using Your Press & Refresh
™
- cont. Care of Your Press & Refresh
™
Troubleshooting Guide
Cleaning & storing
1
Turn the garment steamer off
“O”.
2 Unplug the appliance from the
electrical outlet.
3 Let the appliance cool
completely for approximately
30 minutes.
4
Empty the water from the
water tank.
5 Wipe the exterior of the
garment steamer with a damp
cloth and wipe dry if needed.
9 Hand wash the bonnet in cold
water with a mild detergent and
let air dry completely before
using again. Do not dry in
clothes dryer.
10
To re-attach the bonnet, pull
one corner of the bonnet over
the steam nozzle then the other
corner. Secure the bottom of
the bonnet to the nozzle using
the bottom tab.
PROBLEM POSSIBLE REASONS SOLUTIONS
There is no
steam.
The steamer is not turned on.
There is not enough
water in the unit.
Verify that the blue light on the unit is lit. If not,
check that the unit is plugged in and the on/off
button is raised and in the on “I” position.
Verify that the water tank is at least half way full
or fill to the max fill line.
The nozzle leaves
water drops on the
garment.
You are not using the steam
bonnet.
The steam bonnet is
too wet.
The frame has condensation.
The small steam bonnet must be in place
at all times during usage.
The bonnet prevents water drops being left on
the garment and to removes impurities from your
water.
Let the unit cool for 30 minutes, remove the
steam bonnet and let it dry out before using
again or replace with a new bonnet.
Let the appliance cool and wipe the frame off.
6 Bundle up the power cord and
secure it with the VELCRO ®
strap that is attached to the
power cord. Always store your
appliance in a cool, dry area.
Care & use of the small steam
bonnet
7
The steam bonnet helps filter
impurities from your water.
It might become slightly
discolored over time.
8
Let the steamer cool completely
before removing the bonnet.
Gently pull on either side of
the bonnet to remove from the
steam nozzle.