5
Plug E
(A2547H-5P)
TTL Cable:
PIN1: NC
PIN2: NC
PIN3: GND
PIN4: TX/RS232 TX
PIN5: RX/RS232 RX
The end of the J30J-15 signal cable is plugged into the J30J-15 connector of the oblique
camera. The power end is XT30 male, which is used to supply power to the camera; the
three-pin signal plug (male) is the camera shutter hot shoe wire.
The power supply for oblique camera use the unified external power supply design. The
device is compatible with 12V~50V DC power supply. When the camera is working, the
instantaneous power supply needs to reach 65W to ensure the normal operation of the
device; when the camera is reading data, it use the Type-C cable to connect camera with
computer, doesn’t need external power to camera.
2.2.3 Camera Mounted on Other Drones
1) The bottom of the camera is square with two sets (8pc) of M3 threaded holes. The two
sets of threaded holes are in "×" and "+"-shaped steps, respectively located on the square