Place some masking tape over
every LED hole on the front panel.
Be aware of not blocking any other
component’s hole with the tape.
The LEDs are special flat top
models intended to be mounted
flush with the front panel. The
masking tape will help you to do
this neatly.
Once the panel is ready, mount it
on the top PCB and secure it with 4
nuts: 1 on the Time potentiometer
and one on Time, Mode & Sum jack
connectors.
Check the alignment of the top
PCB and front panel, the two must
be parrallel. Now, push every LED
through their holes until they sit
flush with the panel and stick to the
tape. Once they are all in place,
you can solder them and trim their
legs.
6. Front panel and LEDs
Potentiometer nut
P2
Jack nuts (x3)
P2
www.shakmat.com
•
22/26
