www.shakmat.com
•
18/26
It’s time to solder the fifteen jack
connectors. Four of them has their
outer ground leg soldered on an
adjacent pin from the previously solde-
red header.
For these four jacks, you need to cut
about three millimeters off the outer
ground leg (as shown in the picture
above) in order to be able to solder
correctly to the adjacent pin header.
Be sure to lay the jacks completely flat
on the PCB before soldering. If those
jacks aren’t perpendicular, the front
panel will be very hard to mount.
If one of the jack is not perfectly
perpendicular with the PCB, you can
reheat the pads and push it down with
your thumb to re-align.
5.2.10
Jack connectors (x15)
P2
Cut!
4x
Solder!
4x
