4
3
1. External Mast Stem
(for mount kit or steel base weight option)
2. Clamp with Handle 6. Strut
3. Pole 7. Arm
4. Lower Hub 8. End Fitting
5. Upper Hub 9. Canopy
D I A G R A M & P A R T S L I S T
I N S T A L L A T I O N O P T I O N S A N D G U I D E L I N E S
There are four standard installation options which provide the best stability for the Libra.
Depending on your situation, you will have requested one or more of the Libra base options
at the time of your order.
1. CONCRETE MOUNT KIT
- This kit includes a base plate, four (4) plate bolts and one
(1) allen wrench.
2. IN-GROUND MOUNT KIT
- This kit includes an in-ground fitting, four (4) plate bolts
and one (1) allen wrench.
3. STEEL BASE WEIGHT
- Square and round solid steel base weights are available to
match square and octagon canopy shapes.
4. FREE STANDING BASE
- You may opt to use a free standing base for your Libra
umbrella. Any free standing base with a stem for a 1.57” diameter pole will work. We
recommend a minimum of a 100 lbs. base weight for this umbrella.
NOTE: REFER TO BASE WEIGHT MATRIX AND SEPARATE
MANUAL FOR BASE ASSEMBLY PRIOR TO PROCEEDING.
A S S E M B L Y I N S T R U C T I O N S
Two-person team is recommended for assembly.
After you installed your mount kit, steel base weight, or have set up your free standing
base, you are ready to install your umbrella.
If using a mount kit or steel base weight
, install external mast
stem to mount kit or steel base weight. Bolt external mast stem
to mount kit or steel base weight with 4 supplied bolts and
tighten with allen wrench to secure in place. Lift complete
umbrella and slide into external mast stem. Rotate canopy to
desired position and secure in place by tightening clamp with
handle.
If using a free standing base
, lift complete umbrella and
insert through base stem. Tighten stem knobs to secure
umbrella in place.
You are now ready to operate your umbrella!
Summary of Contents for LIBRA-20S
Page 1: ......
