Shademaker GALAXY-35S, Owner'S Manual

Page: 7 / 12

6 5
c. Expose the mast cord. The cord should be visible
between the boom’s elbow (8) and the mast (7).
d. Carefully remove plastic covering from the mast cord,
using caution not to damage the cord itself.
NOTE: Take note of the pulley at the end of the
mast cord. It will be attached to the end of the
boom. It is important the pulley remains tied to
the hole in the boom.
DO NOT REMOVE this
tie until instructed to do so .
STEP 2:
1. Remove bolts using allen wrench from both
sides of the elbow.
2. Using a two-person team, lift the mast and fit it into
the elbow.
Elbow
Mast
Mast
Mast Cord
Do not remove tie!
3. Make certain the holes in the mast align with the
holes in the elbow.
4. Insert all bolts back into the elbow and tighten with
allen wrench, securing the mast to the elbow.
Note:
Do not use power drill. May cause damage to
umbrella.
NOTE:
Galaxy must be installed with base plate and
internal stem or in-ground fitting and internal stem. Once
installed, proceed to step 3.
STEP 3:
NOTE: If Galaxy is installed on a Zeus base, base lid must be placed over the base frame
prior to the next step.
1. Using at least a two-person team, lift frame out
of packaging and slide onto stem.
2. Grab the mast and rotate it on the stem
to ensure that the holes drilled in the
mast and stem are aligned.
3. Upon finding the appropriate position,
insert the 4 mast stabilizer bolts into the
mast and tighten to secure the mast to
the stem using allen wrench.
Note:
Do not use power drill. May cause damage to umbrella.
4. Insert the handle (6) into the winder (5) and use the provided hex wrench to tighten it
into place.
Tighten with
hex wrench