PAGE 3
PAGE 2
OPERATION
THE OWNER IS RESPONSIBLE FOR MAINTAINING ALL DECALS AND WARNING LABELS AND
MAINTAINING THE UNIT IN GOOD WORKING ORDER. SAFETY INFORMATION SHOULD BE EM-
PHASISED AND UNDERSTOOD PRIOR TO USAGE. THIS JACK SHALL BE INSPECTED AS PER THE
INSTRUCTION MANUAL BEFORE EACH USE.
IT IS THE OWNER’S/OPERATORS’ RESPONSIBILITY TO STUDY ALL WARNINGS, OPERATING
AND MAINTENANCE INSTRUCTIONS CONTAINED ON THE PRODUCT LABEL AND WITHIN
THIS INSTRUCTION MANUAL TO ENSURE PROPER OPERATION OF THIS JACK. THE OWNER/
OPERATOR SHALL RETAIN THESE PRODUCT INSTRUCTIONS FOR FUTURE REFERENCE.
THIS JACK SHALL BE MAINTAINED IN ACCORDANCE WITH THE PRODUCT INSTRUCTIONS. NO
ALTERATIONS SHALL BE MADE TO THIS JACK.
INSPECTION
BEFORE EACH USE A VISUAL INSPECTION SHALL BE MADE FOR ABNORMAL CONDITIONS
SUCH AS CRACKED WELDS, DAMAGED, BENT, WORN, LOOSE OR MISSING PARTS.
THIS JACK SHOULD BE INSPECTED IMMEDIATELY IF IT IS BELIEVED TO HAVE BEEN SUBJECTED
TO AN ABNORMAL LOAD OR SHOCK. OWNER/OPERATORS SHOULD BE AWARE THAT REPAIR
OF THIS JACK REQUIRES SPECIALISED EQUIPMENT AND KNOWLEDGE.
LOWERING A VEHICLE
1.
TURN THE RELEASE VALVE CLOCKWISE TO THE CLOSED POSITION.
2.
PUMP THE HANDLE TO LIFT THE VEHICLE OFF THE JACK STANDS.
3.
REMOVE THE JACK STANDS. DO NOT GET UNDER THE VEHICLE WHILE THE VEHICLE IS
BEING LOWERED.
4.
TURN THE RELEASE VALVE SLOWLY COUNTER CLOCKWISE TO LOWER THE VEHICLE
ONTO THE GROUND.
RAISING A VEHICLE
1.
MAKE SURE THE JACK AND VEHICLE ARE ON A HARD LEVEL SURFACE.
2.
ALWAYS SET THE VEHICLE HANDBRAKE AND CHOCK THE WHEELS.
3.
CONSULT THE VEHICLE OWNER’S MANUAL TO ASCERTAIN THE LOCATION OF JACKING
POINTS AND POSITION THE JACK BENEATH THE LIFT POINT.
4.
TURN THE RELEASE VALVE CLOCKWISE TO THE CLOSED POSITION BUT DO NOT OVER
TIGHTEN.
5.
TO RAISE THE VEHICLE PLACE THE HANDLE INTO THE SOCKET AND PUMP UP AND
DOWN.
6.
PLACE JACK STANDS BENEATH THE VEHICLE AT LOCATIONS RECOMMENDED BY THE
VEHICLE MANUFACTURER. DO NOT WORK UNDER THE VEHICLE WITHOUT THE USE OF
JACK STANDS. JACKS ARE NOT DESIGNED TO MAINTAIN HEAVY LOADS FOR LONG PE-
RIODS OF TIME. DO NOT ATTEMPT TO PLACE JACK STANDS SIMULTANEOUSLY UNDER
BOTH ENDS OF A VEHICLE OR ALONG ONE SIDE OF A VEHICLE.
7.
TURN THE RELEASE VALVE SLOWLY COUNTER CLOCKWISE TO LOWER THE VEHICLE
ONTO THE JACK STANDS.
SPECIFICATION
MAX CAPACITY
2 TONNE
RETRACTED HEIGHT
89MM
FULLY EXTENDED
359MM
WWW.SGS-ENGINEERING.COM
