PAGE 3
LOWERING A VEHICLE
1. Turn the release valve clockwise to the closed position.
2. Pump the handle to lift the vehicle off the jack stands.
3. Remove the jack stands. Do not get under the vehicle while the
vehicle is being lowered.
4. Turn the release valve slowly counter clockwise to lower the vehi-
cle onto the ground.
RAISING A VEHICLE
1. Make sure the jack and vehicle are on a hard level surface.
2. Always set the vehicle handbrake and chock the wheels.
3. Consult the vehicle owner’s manual to ascertain the location of
jacking points and position the jack beneath the lift point.
4. Turn the release valve clockwise to the closed position but do not
over tighten.
5. To raise the vehicle place the handle into the socket and pump up
and down.
6. Place jack stands beneath the vehicle at locations recommended
by the vehicle manufacturer. Do not work under the vehicle
without the use of jack stands. Jacks are not designed to maintain
heavy loads for long periods of time. Do not attempt to place jack
stands simultaneously under both ends of a vehicle or along one
side of a vehicle.
7. Turn the release valve slowly counter clockwise to lower the vehi-
cle onto the jack stands.
