PAGE 5
PAGE 4
GENERAL SAFETY INFORMATION
OPERATING INFORMATION
Chemicals, including lead, are contained in this
product or its power cord. Wash hands after
handling.
Wear protective gear to prevent direct contact
with dust that is created during use on
different materials. Dust contains harmful
chemicals known to pose serious health risks.
DO NOT USE the abrasive blaster around
combustible or flammable objects or
substances. Abrasive materials may generate
sparks or static electricity which can cause fires.
Please wear leather or rubber soled footwear
and stand on the ground to avoid static elec-
tricity. A grounded wire attached to the nozzle
retainer will safely remove the static electricity.
Operation Method
Connect air and power supply, open operation door,
load abrasive, place work piece on grate, lock the door, turn
dust collectors on then the air intake valve, adjust working
pressure and step on the foot pedal to start.
Operating Principle
Depressing the foot pedal allows air flow to the
pressure tank, closing the sealing head and allowing
abrasive to flow through the hose. Opening the gate valve
on the tank controls the flow of abrasive. Open gate valve
slowly until desired abrasive flow is obtained.
Note: open-
ing the gate valve too much will cause pulsing and can also
cause the nozzle to clog.
To depressurize the tank, close
the air inlet valve and depress the foot pedal until pressure
gauge reads zero pressure. When the foot pedal is in the rest
position, air flow to the sealing head is shut off allowing the
abrasive to recycle back into the tank.
WWW.SGS-ENGINEERING.COM