21
Replacing rotating gobos
TORX
20
Cover Gobo Wheel 1
Cover Gobo Wheel 2
To replace one or more gobos:
•
Disconnect the device from power and allow to cool.
•
Position the head and apply the tilt lock.
•
Before removing one of the rear head covers, identify where gobo wheel
covers 1 and 2 are positioned. When the head of the device is facing
upwards, cover gobo wheel 2 is located at the side of the head corre-
sponding to the pan lock (A). See figure below.
•
Remove the relevant rear head cover.
•
Remove the gobo wheel cover for access to the gobo wheel.
•
Turn the relevant gobo wheel until the gobo you want to replace is
accessible.
•
Unhook the end of the spring and turn it upwards. Pull the gobo holder
out of the gobo wheel.
Manual_G_Spot_EN_170x113,3.book Page 21 Thursday, October 30, 2014 1:04 PM
